Car diagnostic tools for OBD2
OBD2 engineer teach you how to use Xhorse Condor XC-Mini cut keys if parts of the car are missing bitting on door lock/trunk lock/ignition lock.
SEC-E9 Key Cutting Machine
Step1: Select Car information
Connected to the power supply, open Condor XC-MINI
Enter main interface, Click on ‘Find Bitting’
Select car maker ‘’Toyota’ Key cutter Machine
Enter ’TOY43’ and click on ‘Confirm’
Select key type and click on ‘Confirm’
Enter known bitting ‘23112134’
Enter unknown bitting as ‘?’
(Possible key bitting will be listed. Note that system has sorted the codes by the most
economical way in order to save blank keys. For example, the bitting under ‘First key’ only
needs three blank keys, the bitting under “Second Key” need another three blank keys, then the ‘third Key’…)
Step2: Prepare Key
Then push M1 clamp and tighten the clamp lock
Next put the blank TOY43 key on the M1 clamp and tighten it
Close the protective shield
Step3: Begin cutting
Click on ‘Find Bitting Code’
And click on ‘Cut’
It is processing…
Cutting complete!
You can clean up the clamp, probe and the cutter using the brush.
Article from:http://chasencai.over-blog.com/2018/06/how-to-cut-toy43-key-using-condor-xc-mini-find-bitting.html
